DigiTech HARDWIRE CM-2 Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pedal Musik DigiTech HARDWIRE CM-2. DigiTech HARDWIRE CM-2 20 halaman. Digitech tube overdrive owner's manual

Halaman Cetak

Battery Operation

In the event that battery power is completely depleted, HardWire pedals

automatically switch into bypass. This eliminates the need to remove the

pedal from your pedal chain if the battery is dead. To replace the battery, do

the following:

Using the tip of a /" guitar cable, push in one of the Release Pins in on

either side of the Foot Switch, and remove it from the pedal chassis.

Remove the battery from the battery compartment and disconnect the

battery cable.

Connect a new battery to the battery cable and put it back in the bat-

tery compartment. Make sure the battery cable does not interfere with

the spring or pedal switch arm.

Place one hole of the Foot Switch over its corresponding pin.

Push the opposite pin in and lower the other side of the Foot Switch

into place over the depressed pin. Release the pin. When the Foot