Argo CLIMIA CMK 4000 WiFi Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pendingin Udara Argo CLIMIA CMK 4000 WiFi. Argo CLIMIA CMK 4000 WiFi 20 halaman. Room air conditioner with remote condenser

Halaman Cetak

Room air conditioner with remote condenser

08 - USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES

• Remove the lid in the rear part of the remote control unit.

• Insert two AAA alkaline batteries of 1,5 V-DC making sure that point in the direction marked in the battery

compartment.

• Set the clock (see procedure on page 8). Remote controller is now ready for operation.

• The batteries last about six months. Depending on how much you use the remote control unit. Remove the

batteries if you do not use the remote control unit for more than one month. Replace the batteries when

the battery symbol appears on the remote control (

• The batteries of the remote control contain polluted substances. Exhausted batteries must be disposed

according to the laws in force.

HOW TO REMOVE BATTERIES

• Remove the lid.

• Press the battery toward the negative end and lift it out by its positive end (as shown in the figure).

• Remove the other battery in the same way.

Programming the remote control

• The batteries must be inserted in the remote control.

• When the keyboard is locked (the icon

Hold for 2 seconds until the icon

• Press and hold the ECO button

The remote control is now configured for use with your unit. This setting is retained even if the batteries are removed.

TEMPERATURE SENSOR SELECTOR

• Under normal conditions the room temperature is detected and checked by the temperature sensor placed in the remote

controller ( IFEEL

icon displayed ).This function is designed to provide a comfortable room temperature by transmitting the

temperature control command from the location next to you. When using this function, the remote, control should always be

pointed at the air conditioner, therefore it should be placed in a position in which it is visible by the indoor unit (for example,

do not put it in a drawer).

• It is possible to disable the remote controller room sensor pressing the FAN/IFEEL

icon on the remote controller display lights off and the sensor placed in the air conditioner becomes active.

NOTE

The remote control unit transmits signals to the indoor unit each time you press a key and at any temperature change detected by

the internal sensor. In case of troubles (low batteries, remote control placed in a position not visible by the indoor unit,...) room tem-

perature control is automatically switched to the sensor of the indoor unit. In this case, the temperature around the remote control

unit may differ from the temperature detected in the air conditioner position.

PERATION WITH THE REMOTE CONTROL UNIT

When using the remote control unit, always point the unit transmitter head

directly at the air conditioner receiver.

lights up on the display), unlock the keyboard by pressing the power button

turns off.

for 5 seconds until "02" appears on the display.

CMK 4000

button for a few seconds. In this case the

REMOTE CONTROL UNIT

FERNBEDIENUNG

INDOOR UNIT

INNENEINHEIT

IR-EMPFÄNGER

RECEIVER

IR-SENDER

TRANSMITTER HEAD

RESE T