Argo DD Panduan Petunjuk Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pendingin Udara Argo DD. Argo DD 16 halaman. Air conditioner without outdoor unit

Halaman Cetak

WARNING! The supplied plastic sheet can be used for wall

thickness up to 50 cm; in special cases (i.e. installations

in a garret) it can be necessary to utilise longer tubes.

The maximum allowable length is 2 m. You can go to any

building material retailer, buy the plastic tube of the same

diameter (ø160 mm), of the proper length and cover it

outside with insulating material (thickness: about 3-4 cm).

- Fix the hanging bracket to the wall in the position

indicated on the full scale diagram.

The quantity and the type of rawl plugs depends on the

consistence of the wall; do not let any space between

the panel and the wall.

- Hang up the unit at the bracket by simultaneously

inserting the condensate drainage pipe into the wall hole.

- Predispose a condensate drainage toward the outside

making a hole Ø 35 mm as indicated on the full scale

diagram. Assure always a positive slope of at least

1cm/m.

3.2 - ELECTRICAL CONNECTION

The air conditioner is equipped with a power cable with

plug (the electrical connection of the unit is Y type with

cable prepared in a special way; any replacement must

only be carried out by the authorized Service Center).

CAUTION

Before connecting the air conditioner, be sure that:

• The voltage of the mains power supply is the same as

the voltage shown on the nameplate.

• The power supply line has a ground connection and

it is correctly sized for maximum electrical input of

the air conditioner (minimum cable cross-section:

1,5mm

• The air conditioner is powered only through a socket

compatible with the plug supplied.

Main switch for disconnection from the supply line must

have a contact separation in all poles that provides

full disconnection under category III overvoltage

conditions.

Connect the unit inserting the plug in the power socket.

ELECTRICAL CONNECTION THROUGH A CABLE BUILT

INTO THE WALL

It is possible to proceed with the electrical connection

through a cable built into the wall as indicated in the full

scale diagram (recommended connection for installation

of the unit in the upper part of the wall).

• Disconnect the main switch before making the elec-

trical connection.

• Disconnect the power cable with plug from the ter-

minal block.

• Connect a similar cable, pass it through the appro-

priate hole on the full scale diagram (cut the rubber

grommet) and connect it to the cable built into the

wall.

Plastic tubes ø 160mm

Insulation