Argo DD DCI Panduan Petunjuk Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pendingin Udara Argo DD DCI. Argo DD DCI 16 halaman. Air conditioner without outdoor unit

Halaman Cetak

ON/OFF CONTACT CONNECTION

The air conditioner is equipped with an ON / OFF contact

(in very low voltage, to be connected to a clean contact, not

in tension); When opening the contact, the air conditioner

is in stand-by.

Through this contact it is possible to connect an external

device that inhibits the operation of the air conditioner,

as for example: window opening contact, remote on / off,

infrared presence sensor, enabling badge, etc.

It is recommended to use a double insulation cable.

The unit is supplied with a pre-installed jumper between

2 poles of the terminal block; remove the jumper before

connecting the remote ON / OFF contact.

3.3 - HOW TO MOUNT THE FRONT PANEL AND THE

BOTTOM PANEL WITH FILTER

Mount the front panel taking care not to scratch it; operate

as follows:

- Connect the receiver cable to the connector (1).

- Grasp the panel, keeping it slightly raised relative to the

unit and bring it into place by inserting it first right and

then left. (See figure)

- Slide it down in order to fix the three lateral hooks (2) to

the structure.

CAUTION

- Loosen the screws of the two lower safety hooks (2),

move them outwards and re-tighten them again to

secure the panel, so that it is not accidentally removable.

- At this point mount the bottom panel with filter (see

figure) as follows:

- Place the panel vertically and insert it under the unit on

the back so that the four hooks (3) fit into place.

- Rotate the panel upwards to fix the front part to the

structure through the central hooks (4); help yourself

by pressing the central hooks with two fingers.

Once the installation is finished, verify the correct operation

of the air conditioner.

BOTTOM PANEL WITH FILTER