DigiTech XP100 Panduan Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pedal Musik DigiTech XP100. DigiTech XP100 4 halaman.

ongratulations, and thank you for your purchase of the Digitech XP-100. The XP-100 offers not one,

not two, but numerous effects in one compact heavy duty pedal chassis design. With the XP-100, you get

classic Wah effects, Pitch shifting, Whammy effects, along with a Volume controller and a Chromatic tuner.

To keep things quiet, the XP-100 even comes equipped with an adjustable Noise gate.

This owner's guide is provided to get you up and going with the XP-100 and use it to its full potential.

Front and Rear Panel Controls and Functions

Signal LED - Indicates that signal is entering the XP-100.

Clip LED - Indicates that signal is clipping in the XP-100.

Status Display - The Status Display window shows the current information including: bypass, current

effect program number, and Chromatic Tuner information. When the XP-100 is in Program mode

(Factory or User), the display will either read: 01-29 (Factory) or U1-U6 (User).

*Note- A complete listing of all Factory programs is located on the bottom panel of the XP-100.

Program UP/(Hold)DOWN Switch - Lets you select programs. Pressing once will move up through the

program menu. Press and hold and the XP-100 will move down through the program menu.

BYPASS/(Hold)TUNER Switch - Puts the unit into Bypass by pressing the footswitch once. To select the

Tuner, press and hold the footswitch until the display reads: tu , indicating that you are in Tuner mode.

Expression Pedal - Controls the selected effect or volume.

Input Level Control - Sets the amount of signal being sent into the unit. The ideal setting for the input

control of the XP-100 is to set the input level at a point where the Clip LED indicator occassionally

lights.

8. Input Jack - Connect instrument here using 1/4" guitar cord.

9. Effect Output - The Effect output sends only the effected signal out.

10. Dry Output - The Dry output of the XP-100 sends only the un-efffected signal out.

11. Mode/(Hold)Program-Gate Calibration - This button is used to put the XP-100 in and out of User