DigiTech BP355 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Perekaman DigiTech BP355. DigiTech BP355 2 halaman.

Halaman Cetak

SELECTING, EDITING, & STORING PRESETS

A. To select a preset, press the UP or DOWN footswitch.

B. Turn the TONE LIBRARY and EFFECTS

LIBRARY knobs to select other tones/

effect chains.

C. Press the UP/DOWN EDIT buttons to

select a specific effect for editing (the

selected effect LED will light). Press the

Selected

TONE LIBRARY knob to turn the effect

effect

on/off. Look at the parameter matrix

and use the KNOBS to edit the effect.

Press to

D. To exit Edit mode, press the UP or

edit effect

DOWN footswitch.

E. To store the preset, press the STORE

button.

F. Use the TONE LIBRARY and EFFECTS

LIBRARY knobs to edit the preset name.

G. Press the STORE button a 2nd time.

H. Optional: Press the UP or DOWN

footswitch to relocate the preset.

Press for

Press the STORE button a 3rd time to

Preset down

store the preset.

SWITCHING AMPS & USING STOMP MODE

A. To toggle between amps A and B, press the

AMP A-B footswitch. Amps can be edited by

following the instructions in step 3 and selecting

"AMPLIFIER" in step 3B. Pressing the AMP A-B

footswitch will then switch between amps for

editing.

NOTE: Amps cannot be toggled when in Stomp

mode.

B. To use Stomp mode, press the AMP A-B and UP

footswitches simultaneously. The display will

briefly read "STOMP", indicating Stomp mode is

now active.

C. Pressing the 3 footswitches will now turn the

"DISTORTION", "CHORUS / FX", and "DELAY" effects

on and off.

D. To exit Stomp mode, press the AMP A-B and UP

footswitches simultaneously again. The display

will briefly read "PRESET", indicating that the UP

and DOWN footswitches will once again select

presets.

Press for

Preset up

• 801.566.8800 • digitech.com

USING THE DRUMS / LOOPER

A. To enable the Drums, press the DRUMS button.

Drum settings can be edited by following the

instructions in step 3B and selecting the "LOOPER"

row in the matrix.

B. To use the Looper, make sure the DRUMS button

is off. Then press and hold the LOOPER footswitch

for 2 seconds. The display will read "LOOPER",

indicating Looper mode is now active.

C. Press the LOOPER footswitch to arm the looper for

recording. The display will read "ARMED".

D. Begin playing. When done, press the LOOPER

footswitch again on the same downbeat you

started on.

E. While the loop is playing, press and hold the

LOOPER footswitch to record overdubs.

F. Press the LOOPER footswitch to stop and play the

looper.

G. To clear the loop, stop playback then press and

hold the LOOPER footswitch for 2 seconds.

H. To exit the Looper, stop playback then press and

Press to enter/exit

Press to

hold the LOOPER footswitch for 2 seconds.

Stomp mode

toggle Amps

DigiTech is a registered trademark of Harman.

DigiTech

Drums

on/off

Hold to enter/exit Looper,

press to operate Looper

PN: 5059481-A

QUICK START GUIDE