Cisco TelePresence MX700 Panduan Instalasi - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Konferensi Cisco TelePresence MX700. Cisco TelePresence MX700 28 halaman. Single camera on a free standing floor stand or a floor stand secured to the wall
Juga untuk Cisco TelePresence MX700: Panduan Instalasi (32 halaman), Panduan Memulai Cepat (12 halaman), Panduan Instalasi (29 halaman), Panduan Instalasi (32 halaman), Panduan Referensi Cepat (2 halaman), Manual (45 halaman), Manual (45 halaman), Panduan Instalasi (29 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Memulai (46 halaman)

Halaman Cetak
Cisco TelePresence MX700 Panduan Instalasi
Installation guide for Cisco TelePresence MX700 Single camera - Floor stand
19

Start up the system

•
Remove the protection foil from the displays.
•
Make sure the camera can move freely.
•
Insert the network and power cables into the wall outlets.
•
Switch on the system.
The power switch is located directly below the codec, next to
the power connector.
Wait a few minutes while the system starts up. The start-up
may include automatic software upgrade and restart of
Touch 10 and camera.
•
Follow the instructions on Touch 10.
If your system is not set up to be automatically provisioned,
you must configure the system before you can make your
first call. This is described in the Getting Started Guide, which
can be found on the Cisco web site.
78-100218-01 A0 | 2014 APRIL | © 2014 Cisco Systems, Inc. All rights reserved.
Page 25