Cisco TelePresence MX700 Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Konferensi Cisco TelePresence MX700. Cisco TelePresence MX700 32 halaman. Single camera on a free standing floor stand or a floor stand secured to the wall
Juga untuk Cisco TelePresence MX700: Panduan Instalasi (32 halaman), Panduan Memulai Cepat (12 halaman), Panduan Instalasi (28 halaman), Panduan Instalasi (29 halaman), Panduan Referensi Cepat (2 halaman), Manual (45 halaman), Manual (45 halaman), Panduan Instalasi (29 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Memulai (46 halaman)

Halaman Cetak
Cisco TelePresence MX700 Panduan Instalasi
Installation guide for Cisco TelePresence MX700 Single camera - Wall mount
3
Mount left wall bracket
C
Check that the wall bracket is level and mark the required
screw hole positions on the wall. Use at least four screws
when fastening the wall bracket. The wall bracket can be
fastened through any of the horizontal slots.
Fasten the wall bracket in a secure manner ensuring that
the wall's structure is sufficient to support the system load
(screws and mounting hardware not provided; not shown in
illustration).
78-100254-03A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
The lower edge of the screen
image will be at the height of
these horizontal slots.
We recommend that the
distance from the floor to this
line is 70 cm / 27.6 in.
*
If you mount the system higher, note the following consequences:
*
- You may need to increase the distance between the video system and the table in
order for the camera to capture the closest participants.
- The camera gives an elevated view of the room. This view is not optimal for video
conferencing.
Further information:
http://www.cisco.com/go/projectworkplace
2D CAD drawings with measurements:
References)
http://www.cisco.com/go/mx-docs
(Technical
Page 7