Cisco Telepresence MX800 Manual - Halaman 22

Jelajahi secara online atau unduh pdf Manual untuk Sistem Konferensi Cisco Telepresence MX800. Cisco Telepresence MX800 45 halaman. Wall-mounted mx800 single
Juga untuk Cisco Telepresence MX800: Panduan Memulai Cepat (12 halaman), Panduan Instalasi (16 halaman), Manual Penggantian (46 halaman), Manual Penggantian (47 halaman), Panduan Instalasi (30 halaman), Suku Cadang (24 halaman), Panduan Instalasi (16 halaman), Panduan Referensi Cepat (2 halaman), Manual (45 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Memulai (46 halaman)

Halaman Cetak

Slider

Table of contents

Introduction

Example of use: Dimmable lights, volume control.

Create a user interface

Events

API for in-room control

Pressed

Widgets

Changed

Command reference

Released

Troubleshooting

Tips and tricks

Examples

Commands

The visual appearence of the slider changes immediately when you tap or slide

D15358.01 APRIL 2016

it. However, the control system must always send a

Collaboration Endpoint software

version 8.1

video system to tell the new position of the slider. This ensures that the status is

updated accordingly.

Triggered when the slider is pressed

Value: N/A

Triggered when the slider is moved while holding down, and when

the slider is released

Value: 0-255

Triggered when the slider is released

Value: 0-255

SetValue

A slider selects values within a set range. The minimum value is represented

by 0, and the maximum value is represented by 255. When the slider is being

pressed and moved, events are sent maximum 5 times a second.

When you tap the bar, the slider is immediately moved to that new position.

Example:

Press the slider with WidgetId = "slider", and move it into a new

position ("68"), and release.

*e UserInterface Extensions Event Pressed Signal: "slider"

** end

*e UserInterface Extensions Event Changed Signal: "slider:32"

** end

*e UserInterface Extensions Event Changed Signal: "slider:68"

** end

*e UserInterface Extensions Event Released Signal: "slider:68"

** end

<Event>

</Action>

</Widget>

</Extensions>

</UserInterface>

</Event>

Example:

Set the slider with WidgetId = "slider" to position "98".

xCommand UserInterface Extensions Widget SetValue WidgetId: "slider"

command to the

Value: "98"

Terminal mode

XML mode

<WidgetId item="1">slider</WidgetId>

<Type item="1">released</Type>