Cisco TelePresence SpeakerTrack 60 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Sistem Konferensi Cisco TelePresence SpeakerTrack 60. Cisco TelePresence SpeakerTrack 60 22 halaman. Telepresence
Juga untuk Cisco TelePresence SpeakerTrack 60: Lembar data (3 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (14 halaman), Manual Kamera (40 halaman), Manual Kamera (44 halaman)

Halaman Cetak
Cisco TelePresence SpeakerTrack 60 Manual
Cisco TelePresence Precision 60 and SpeakerTrack 60
Contents
SpeakerTrack 60
Video
• Two HDMI cables from the cameras.
Power
•
Power out to cameras (internal connection).
•
Power in: 12 V
, 6.5 A
DC
Always use the provided cables and adapter.
Ethernet
Two Ethernet ports are used for the internal camera control con-
nection. The third connector is used for connecting the codec.
Do NOT connect a camera control cable to the Ethernet
codec port of the device. This will destroy the system.
Microphone connectors
The right set is used for internal connection to the microphone
panel. The left set of connectors is intended for future use.
Kensington lock
The Kensington lock may be used to prevent the camera from
being moved from its place or to prevent theft.
For more information about the internal connection
setup, please see the SpeakerTrack 60 installation guide:
http://www.cisco.com/go/telepresence/docs
D15296.03 Cisco TelePresence Precision 60 and SpeakerTrack 60, APRIL 2016.
Introduction
Physical interface
Physical interface
Connecting the camera
Power out to
Power in
Ethernet
cameras
RJ45
camera control
7
Factory reset
Ethernet
USB*
Microphones
RJ45
on panel
codec
Additional
connectors*
The camera LED is lit during a call on the
camera that is currently sending the live
picture.
The status LED is continuously lit when
power is On, and flickers when receiving
signals from the remote control.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Camera guide
Appendix
Chinch
connectors*
* For future use