DigiTech RPX400 Panduan Pemecahan Masalah - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pemecahan Masalah untuk Perangkat Keras Komputer DigiTech RPX400. DigiTech RPX400 6 halaman. Usb drivers and software installation guide
Juga untuk DigiTech RPX400: Panduan Instalasi Perangkat Lunak (12 halaman), Manual (6 halaman)
Halaman Cetak
I hear doubling of the playback.
• Input monitoring is probably active. Go to Options->Audio->Input Monitoring to
disable.
It's taking forever to install X Edit/Drivers.
• Microsoft .NET framework is required for X Edit to run on Windows PCs. It is a very
large file and if it is not already present on a system, it will take a while to load.
• However in Windows 2000 systems, if McAfee Virus scanning software is installed, a
security issue will cause .NET installation to halt. McAfee must be un-installed – not
just disabled in order for the .NET installation to proceed.
I can't launch X Edit.
• This is usually caused by MIDI problems. Make sure your drivers are loaded correctly
and that the USB cable is inserted securely.
• See the section on driver installation.
My guitar sound is really bright.
• Activate speaker compensation for the desired output jacks.
I don't hear guitar signal in headphones or XLR.
• You are probably using one of the 'Split' modes. Change this selection with the output
mode knob on the setup level of the matrix.
My guitar sounds dark through my amp.
• De-activate speaker compensation for the output jacks that feed the amp.
How can I keep the drums from playing through my amp?
• You can either turn the Drums off or switch to one of the two output modes 'SPLIT1'
or 'SPLIT2' and send Guitar to your amp and drums to the PA.
I am hearing mic/line inputs through my guitar amp.
• You can either turn off the Mic and Line inputs or switch to one of the two output
modes 'SPLIT1' or 'SPLIT2' and send Guitar to your amp and everything else to the
PA.
How are signals routed through the RPx?
• Refer to the routing diagrams in the RPx400 User's Guide
I can't access Learn-a-Lick.
• The USB cable must be disconnected in order to access Learn-a-Lick
Bass, Mid and Treble controls are not working.
• When USB is connected, the Bass, Mid and Treble controls function as USB mix and
level controls. The tone controls can still be accessed from the editing matrix or from
X Edit.
All manuals and user guides at all-guides.com