Cisco TelePresence SX10 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Konferensi Cisco TelePresence SX10. Cisco TelePresence SX10 8 halaman. In-room control on touch 10
Juga untuk Cisco TelePresence SX10: Panduan Instalasi (8 halaman), Panduan Pengguna (26 halaman), Panduan Cepat (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (29 halaman), Panduan Pengguna Awal (9 halaman), Panduan Pengguna (38 halaman), Panduan Pengguna (2 halaman), Panduan Pengguna (37 halaman), Manual (45 halaman), Manual (45 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (5 halaman), Panduan Pengguna (38 halaman), Panduan Pengguna (38 halaman), Panduan Memulai (46 halaman), Panduan Cepat (2 halaman)

Cisco TelePresence SX10 Panduan Instalasi
3.

Connect the cables

2
3
Power
1. Connect the SX10 to your screen with the provided HDMI cable.
2. Connect the LAN cable from the SX10 to an Ethernet wall plug. If Power over
Ethernet (PoE) is available, the SX10 is powered through this cable. Alternatively
you can use a PoE injector.
3. If your network doesn't support PoE, use the provided power adapter.
Connect additional cables for presenting, and external microphone and speakers to
their respective connectors, if needed.
Power over Ethernet (PoE)
The PoE source (network switch or PoE injector) must be located in the same building
as the SX10 device. The maximum cable length when connecting the SX10 to a PoE
source is 50 m / 164 ft.
NOTE:
Do not connect an external device to the USB port.
Ethernet/PoE
1
Monitor output,
HDMI