Argo Misse13DCI Petunjuk Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Pendingin Udara Argo Misse13DCI. Argo Misse13DCI 15 halaman. Room air conditioner with remote condenser

Halaman Cetak

INSTALLATION LOCATION

WARNING

Do not install this air conditioner where there are

fumes or flammable gases, or in an extremely humid

space such as a green house.

Do not install the air conditioner where excessively

high heat-generating objects are placed.

Do not install the air conditioner where the

atmosphere is extremely damp or humid (e.g.

greenhouse or laundry) it could be wetted by drops

of water (i.e. in laundries).

Avoid:

To protect the air conditioner from heavy corrosion, avoid

installing the outdoor unit where salty sea water can splash

directly onto it or in sulphurous air near a spa.

Make sure that there are no obstacles around the

indoor unit affecting the free circulation of air. Do not

block the air intake and outlet of the unit with

curtains or other.Never put objects on the top of the

unit.

NOTE

This air conditioner is equipped with cooling, drying and fan functions.

Details on these functions are provided here following; refer on these descriptions when using the air conditioner.

OPERATING LIMITS

COOLING

OUTDOOR TEMPERATURE 46°C D.B.

MAXIMUM CONDITIONS

ROOM TEMPERATURE

OUTDOOR TEMPERATURE 19°C D.B.

MINIMUM CONDITIONS

ROOM TEMPERATURE

DECLARATION OF CONFORMITY

This product is marked

– Low voltage no. 2006/95/EC. (Standard: EN60335-2-40:2003 (incl. Corr.:2006) + A11:2004 + A12:2005 + A13:2012

+ A1:2006 + A2:2009 con EN 60335-1:2002 + A11:2004 + A1:2004 + A12:2006 + A2:2006 + A13:2008 + A14:2010

+ A15:2011).

– Electromagnetic compatibility no. 2004/108/EC, 92/31 EEC and 93/68 EEC. (Standard: EN55014-1 (2006) +

A1(2009) + A2(2011), EN 55014-2 (1997) + A1(2001) + A2 (2008), EN 61000-3-2 (2006) + A1(2009) + A2(2009),

EN 61000-3-3 (2008)

– RoHS2 no.2011/65/EU.

– Regulation (EU) no. 206/2012, of 6 march 2012, concerning the specifications for ecodesign requirements of air

conditioners and fans.

– Regulation (EU) no. 626/2011, of 4 may 2011, concerning the labeling indicating the energy consumption of air

conditioners.

This declaration will become void in case of misuse and/or non observance though partial of manufacturer's installation

and/or operating instructions.

32°C D.B./23°C W.B.

19°C D.B./14°C W.B.

as it satisfies Directives:

ELECTRICAL REQUIREMENTS

Before using the appliance

Check that the power supply at the location where the

air conditioner is going to be used is 220/240 volt, single

phase.

For your safety care check periodically the conditions of

the electric supply cable; the electrical connection of the

unit is Y type with cable prepared in a special way; in

case you should notice any damage due to usage, call the

nearest After Sale Service to get the cable replaced.

Before connecting the air conditioner to a power

socket, make sure that the socket is provided with

an earth connection.

Verify that the available power supply is sufficient for

running other electrical domestic appliances in use

simultaneously from the same supply. See the data plate

on the unit showing the max. absorbed powers.

Install a double - pole switch, protected fuses of the

delayed type, upstream the electricity wall socket 10A.

Make sure that circuit breakers, fuses, etc. are of sufficient

capacity to handle start - up current (normally for no longer

than a second).

All wiring must conform to the local electrical codes.

Consult your dealer or a qualified electrician for details.

WARNING!

The air conditioner is provided with a time-guard system,

which does not allow re-starting of compressor until after

3 minutes from a previous stop.