ACU-RITE 6024 Buku Petunjuk - Halaman 14

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Monitor ACU-RITE 6024. ACU-RITE 6024 20 halaman. Home environment display

Disable an Alarm

1. Press and release the color-coded button next to the location on the display

for which you wish to disable an alarm.

2. Press and release the "

3. Press and release the "

disable an alarm is highlighted on the display. "ALARM ON" will flash.

4. Press and release the "▲" or "▼" buttons until "ALARM OFF" appears.

5. Press and release the "

location.

6. Repeat steps 3-5, as needed.

Troubleshooting

Problem

No reception

no bars

Temperature is flashing

or showing dashes

If your AcuRite product does not operate properly after trying

the troubleshooting steps, visit www.AcuRite.com or call

(877) 221-1252 for assistance.

" button to enter alarm SET MODE.

" button until the reading for which you wish to

" button to cycle to the next reading for the

If the wireless signal indicator shows no bars:

• Relocate the display and/or synced Monitor/Sensor

(if applicable). The products must be within 330 ft

(100 m) of each other

• Make sure products (display, Monitors, Sensors) are

placed at least 3 feet (.9 m) away from electronics

that may interfere with the wireless communication

(such as TVs, microwaves, computers, etc).

• Use standard alkaline batteries (or lithium batteries

in Monitors and Sensors when temperature is below

-4ºF/-20ºC). Do not use heavy duty or rechargeable

batteries.

Note:

It may take a few minutes for display and

sensor to synchronize after batteries are replaced.

Flashing of the temperature reported by a Monitor/

Sensor is generally an indication of wireless interference

between the sensor and display.

1. Remove the Monitor/Sensor location from the display

(see page 9).

2. Re-add Monitor/Sensor to an available location on

display (see page 10).

Possible Solution