Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor Panduan Pemasangan Perangkat Keras - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Perangkat Keras Jaringan Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor. Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor 36 halaman. User guide

Halaman Cetak

Installing and Removing Line Cards or Motherboards

Figure 2-15

Step 5

Pull the SFP out and place it in a container appropriate for shipping and storage. (See

Figure 2-16

Tip

In an unlikely event of the pull-tab is damaged or missing, use a screwdriver to push on the hinge pin to

unlock the SFP cage latch and pull the SFP out from SFP port

Note

SFPs with RJ-45 connectors require cabling after it is installed, and removal of cables is required before

removing the SFP from the card.

Removing Non-Pull Tab SFPs with RJ-45 Connectors

To remove an SFP with an RJ-45 connector from the muxponder, follow these steps:

Step 1

Remove the cable from the desired SFP.

Step 2

Pull the latch on the SFP out. This releases the SFP from the latch lock of the cage.

Step 3

Pull the SFP out and place it in a container appropriate for shipping and storage.

Cisco ONS 15530 Hardware Installation Guide

2-20

Releasing the SFP

Removing the SFP

Chapter 2

Installing the Cisco ONS 15530

Figure

OL-7706-01

2-16.)