Argo ULISSE ECO Panduan Petunjuk Pengoperasian - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pendingin Udara Argo ULISSE ECO. Argo ULISSE ECO 16 halaman. Room air conditioner with remote condenser
Juga untuk Argo ULISSE ECO: Panduan Instalasi (14 halaman)
Halaman Cetak
PRODUCT IDENTIFICATION
EN
01. Infrared rays remote control unit
02. Monitor panel
03. Supply air deflector
,
4. Return air grille
,
5. Outdoor unit
06. Flexible tube
07. Air filter
08. Electric cable with plug
09. Service tube for condensate evacuation
10. Quick coupling cover
MONITOR PANEL
1. Time setting lamp (TIMER): This lamp lights up when
a timer is activated (see section "TIMER SELECTION").
2. OPERATION lamp: This lamp lights up when you switch
on the unit.
3. STANDBY lamp: this lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
4. Receiver : it receives signals transmitted from the
remote control.
5. Operation button (without remote control): Push
the button to switch on or off the unit (see section
"OPERATION WITHOUT REMOTE CONTROL UNIT").
Press and hold this button for 5 seconds to enable the
WiFi configuration (Only for WiFi models, see "WiFi
INSTRUCTIONS" manual).
WARNING
The OFF position does not disconnect the power. Use the
main power switch to turn off power completely.
1
1
2
3
6
6. Display for room temperature and operation errors:
4
3
7
4
8
4
5
ONLY FOR WiFi MODELS
It indicates the room temperature or any operating error
codes (see AUTO-DIAGNOSIS table).
Each time a remote control signal is received and
stored, the display indicates the set temperature (set
point) for a few seconds.
10
2
5
6
9