3Com 3CWE820A Panduan Memulai Cepat - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Router Jaringan 3Com 3CWE820A. 3Com 3CWE820A 12 halaman. Ethernet client bridge, wireless network solution
Halaman Cetak
Quick Start Guide
7 If you are mounting the ECB on a wall or ceiling, install the bottom
mounting plate, which you removed previously, where desired. After
the mounting plate is installed, place the ECB onto the mounting
plate and snap it into place. Ensure that the ECB is secure.
8 Connect a standard straight-through 10BASE-T Ethernet cable
between the RJ-45 port (ECB ports and connectors are shown
below) on the ECB and the network port on the computer where
you will install the ECB Configuration Utility software.
5 VDC
9 Connect the six-pin DC power cable to the power adapter.
10 Connect the AC power cord to the other side of the power adapter.
11 Connect the round power plug to the ECB power jack labeled 5 VDC.
12 Insert the AC power cord into an AC socket.
13 Verify that the Ethernet LED on the ECB is illuminated.
14 The ECB hardware is now ready for configuration using the ECB
Configuration Utility software. Refer to the following section.
4
Power
10BASE-T
jack
Ethernet port
10
RJ-45
Configuration
Serial port
button
Serial
Config.