Cisco 3020 - Cisco Catalyst Blade Switch Panduan Instalasi - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perangkat Keras Jaringan Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21 halaman. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Juga untuk Cisco 3020 - Cisco Catalyst Blade Switch: Panduan Memulai (37 halaman), Panduan Memulai (31 halaman), Quickspecs (12 halaman), Catatan Rilis (41 halaman), Catatan Rilis (27 halaman), Catatan Rilis (23 halaman), Catatan Rilis (21 halaman)

Halaman Cetak

Cisco 3020 - Cisco Catalyst Blade Switch Panduan Instalasi

Connecting to the 10/100/1000 Ports

Grasp the SFP module between your thumb and index finger, and carefully remove it from the

Step 5

module slot.

Step 6

Place the removed SFP module in an antistatic bag or other protective environment.

Connecting to the 10/100/1000 Ports

The switch module 10/100/1000 ports configure themselves to operate at the speed of attached devices.

If the attached ports do not support autonegotiation, you can explicitly set the speed and duplex

parameters. Connecting devices that do not autonegotiate or that have their speed and duplex parameters

manually set can reduce performance or result in no linkage.

To maximize performance, choose one of these methods for configuring the Ethernet ports:

•

Follow these steps to connect to 10BASE-T, 100BASE-TX or 1000BASE-T devices:

Caution

To prevent electrostatic-discharge (ESD) damage, follow your normal board and component handling

procedures.

When connecting to workstations, servers, routers, and Cisco IP Phones, connect a straight-through

Step 1

cable to an RJ-45 connector on the front panel. (See

repeaters, use a crossover cable. (See the

cable-pinout descriptions.)

Figure 2-13

S Y S T

S T A T

D L X

S P D

W S -C B

S -3 0 2 0

When connecting to 1000BASE-T-compatible devices, be sure to use a twisted four-pair,

Note

Category 5 cable.

Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide

2-18

Let the ports autonegotiate both speed and duplex.

Set the port speed and duplex parameters on both ends of the connection.

Connecting to an Ethernet Port

1 7

U ID

M O D E

C O N S

O L E

2 0

-H P Q

1 7

1 8

1 9

Figure

"Cable and Adapter Specifications" section on page B-3

1 7 x

2 1 x

2 0 x

2 3 x

2 0

2 4 x

1 8 x

2 4 x

Chapter 2

2-13.) When connecting to switches or

Switch Installation

for

OL-8914-02