Cisco 5500 Series Manual - Halaman 8
Jelajahi secara online atau unduh pdf Manual untuk Perangkat Keras Jaringan Cisco 5500 Series. Cisco 5500 Series 19 halaman. Cisco 8500 series
wireless lan controller
Juga untuk Cisco 5500 Series: Panduan Konfigurasi (40 halaman), Panduan Instalasi (34 halaman), Panduan Konfigurasi (50 halaman)
Halaman Cetak
Replacing Hardware Components
You can insert and remove the Flash memory card with the power on.
Note
Before you install a card, verify that the Flash memory card is set with write protection off. The
write-protect switch is located on the front edge of the card when oriented with the printing right side
up and the edge connector end away from you. (See
Figure 7-6
Flash PC card
write protection
Use the following procedure for installing and removing a Flash memory card:
Face the front panel of the switch and hold the Flash memory card with the connector end of the card
Step 1
toward the slot. The connector end of the card is opposite the end with the write-protection switch, which
is shown in
Insert the card into the appropriate slot until the card completely seats in the connector at the back of the
Step 2
slot and the eject button pops out toward you. Note that the card does not insert all the way into the slot;
a portion of the card remains outside the slot. Do not attempt to force the card past this point.
Step 3
To eject a card, press the appropriate ejector button until the card is free of the connector at the back of
the slot.
Step 4
Remove the card from the slot and place it in an antistatic bag.
Removing and Replacing the Power Supply
This section describes the procedure you use to remove and install power supplies for the Cisco Catalyst
5500 switches. Use a flat-blade screwdriver to perform these procedures.
•
•
•
•
Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide
7-8
Locating the Flash Memory Card Write-Protection Switch
Flash PC card
Figure
7-6.
Removing an AC-Input Power Supply, page 7-9
Installing an AC-Input Power Supply, page 7-10
Removing a DC-Input Power Supply, page 7-11
Installing a DC-Input Power Supply, page 7-13
Chapter 7
Maintaining the Cisco Catalyst 5500 Multiswitch Router
Figure
7-6.)
Flash PC card
shown with write
protection off
OL-0542-06