Cisco 5500 Series Panduan Konfigurasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Perangkat Keras Jaringan Cisco 5500 Series. Cisco 5500 Series 50 halaman. Cisco 8500 series wireless lan controller
Juga untuk Cisco 5500 Series: Panduan Konfigurasi (40 halaman), Panduan Instalasi (34 halaman), Manual (19 halaman)

Halaman Cetak

Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs

Configuring a New Controller Starting from Factory

Defaults

Initial provisioning of the controller is done via the command line interface (CLI).

Connect a null modem serial cable between the console port of the controller and the

serial port of a PC.

Open a terminal program, such as Hyper Terminal, and configure the port settings to

9600 baud, no parity, 8 data bits and 1 stop bit.

Power-on the controller. Status of the controller's boot process will appear as the

controller is powering up. Once the controller is running, it will prompt you to run the

Startup Wizard.

The Startup Wizard provides for an easy means to perform initial controller setup and

provisioning. Refer to the Installation and Startup Guide for the appropriate controller,

found at Cisco's website. This document contains a detailed explanation of using the

Startup Wizard for the 5500. Once the controller has been configured via the Startup

Wizard, the remaining configuration can be configured through the switch-web interface

using a Web browser.

If necessary, the controller can be reset to factory defaults. To reset the WLC to factory

default, you must reboot, then type Recover-config at the CLI. This only works before the

first time a user logs in via the console.

A few advanced commands must be set from the command line interface after the rest of the

controller has been configured. These are noted in the instructions below.

Connecting to the Controller Via a Browser

Connect to the WLC by pointing your internet browser to the URL: https<IP_Addr>

(where <IP_Addr> is the IP address of the management interface of the WLC).

Click the Login prompt. The default User Name and Password is admin.

Once logged in properly, a page similar to the one below displays on version 8.1+. All

other versions go directly to the screen in step 4.

Click the Advanced button on the 8.1 or later version screens.

721-1001-000-AH.docx

December 2016