Argo Chic Panduan Petunjuk Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemanas Argo Chic. Argo Chic 6 halaman.
Halaman Cetak
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below)
Open the battery cover at the rear of the remote control (press and pull the cover).
Place the battery into the cover, observing the correct polarity. Insert the cover onto the remote control.
Information for correct disposal of the battery in accordance with the European Directive 2006/66/EC
Please replace battery when its electricity charge is used up: please do not eliminate this battery together with normal
household waste. It must be taken to special local community waste collection centres or to a dealer providing this service.
Disposing of a battery separately avoids possible negative effects on the environment and human health deriving from an
inappropriate disposal and enables its components to be recovered and recycled to obtain significant savings in energy and
resources. In order to underline the duty to dispose of this equipment separately, the battery is marked with a crossed-out
dustbin.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
FAN MODE (FAN)
Press the button ON/OFF on the control panel (III) or on the remote control
on the display lights and the unit begins to operate in fan mode (the ceramic resistance is not active – ho heating).
The display shows the room temperature and the LED (°C) lights.
HEATING MODE
•
ECO mode selection – Energy saving (1000W):
Press a second time the button III on the control panel or the button
"E"
The LED
•
COMFORT mode selection (2000 W):
press a third time the button III on the control panel or the button
Both the LEDS
•
SWING mode selection (SWING):
press a fourth time the button III on the control panel or the button
The LED
TIMER OFF
•
TIMER OFF SETTING:
press the button
The LED
lights. Press this button once or more times to set the operation time (1-8 h).
TEMPERATURE SETTING:
•
Temperature adjustment (ONLY WITH THE REMOTE CONTROL):
press the buttons
If the selected temperature is higher than the room temperature, the unit automatically turns on and heats until
the selected temperature is reached. The unit will automatically maintain the temperature at a constant level.
Press the button
NB.
To completely shut the fan heater off, press the button III on the control panel or the button
remote control.
After switching off the fan heater, the fan will continue to to run for a few seconds to cool the heating
elements
V 05/14
HOW TO USE THE FAN HEATER
on the control panel lights.
"C E"
on the control panel light.
lights.
on the control panel or the remote control.
and
in order to adjust the temperature (from 10 to 49°C).
to cancel the temperature setting.
. The horizontal flap opens, the LED
on the remote control.
on the remote control.
on the remote control.
on the
11