Argo CLOE Panduan Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemanas Argo CLOE. Argo CLOE 12 halaman. Ceramic table fan heater

ECO mode:

a) The reference temperatures are 25 ° C and 18 ° C

When the ambient temperature is below 18 ° C, the appliance operates at high heating power (2000W).

When the ambient temperature is between 18 ° C and 25 ° C, the appliance operates at low heating power (1300W).

When the room temperature exceeds 25 ° C, the heating mode stops.

b) In ECO mode, when the room temperature reaches 25 ° C, the heating mode and the Oscillation function (if previously

set) are interrupted, while the other functions remain active. When the room temperature decreases by 2 ° C below the set

temperature, the fan heater automatically resumes the heating mode and the Oscillation function (if previously set).

c) In ECO mode, when the temperature reaches 18 °C, the fan heater operates at low heating power. When the room

temperature decreases by 2°C below the set temperature, the appliance automatically starts to operate in high heating

power.

In ECO mode it is not possible to adjust the temperature, the heating power (high and low) and the ventilation.

Other functions

Ventilation: ventilation must be active when the resistance is in operation. If the resistance is turned off, the ventilation

stops with a delay of 60 seconds to allow the product to cool down.

Display lighting: If no selection is made after 1 minute of operation of the fan heater, the brightness of the display is

reduced by 1/3 compared to full lighting, so as not to disturb during the night. To restore full display illumination, touch any

key on the control panel.

Memory function: if you activate the unit from stand-by (not the first time it is turned on), by touching the button

the appliance starts operating according to the latest settings, except for the Timer, which is not stored.

Automatic switch-off: If the timer is not set, the device switches off automatically 12 hours after the last operation on the

panel.

Anti-tip device

This appliance is equipped with an anti-overturning system, which automatically stops the operation of the fan heater in

case of accidental overturning of the appliance. To reset it, disconnect the cable from the socket for a few minutes, put the

appliance back in its vertical position, and reconnect the cable to the socket. If the problem persists, contact a qualified

service center.

Overheating protection device

This appliance is equipped with an overheating protection system, which automatically stops the operation of the fan

heater, while the fan continues to operate for 60 seconds. If the protection system activates, turn off the fan heater,

disconnect the power cord and let the appliance cool down completely.

Contact a qualified service center.

V 05/21