Cisco 6160 Panduan Pemasangan Perangkat Keras - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Perangkat Keras Jaringan Cisco 6160. Cisco 6160 21 halaman. Without a pots splitter configuration
Juga untuk Cisco 6160: Panduan Referensi Cepat (38 halaman), Catatan Pemasangan Dan Penggantian (18 halaman), Manual Prosedur Instalasi (32 halaman)

Site Requirements

2.1.4.3 Installation and Replacement Suggestions

The following examples list recommended installation and replacement practices for the Cisco 6160

system cards.

Any card that is only partially connected to the backplane can disrupt system operation.

Caution

•

2.2 Site Requirements

This section describes requirements for the site at which the Cisco 6160 system is to be installed. Before

you install the Cisco 6160 system, ensure that all the criteria in this section are met. This section includes

the following information:

•

Proper operation of the Cisco 6160 system depends on a proper environment. Before you install the

Cisco 6160 system, ensure that all the criteria in this section are met. This section describes the

following environmental requirements:

•

Cisco 6160 Hardware Installation Guide

2-10

Do not force the line card into its slot. This action can damage the pins on the backplane if they are

not aligned properly with the line card.

Ensure that the line card is straight and not at an angle when you install the line card in the slot.

Installing the line card at an angle can damage the line card. Use the guide rails to install the line

card correctly.

Fully depress the ejector tabs to ensure that the line card connector mates with the backplane

correctly. Firmly seat the line card in the slot.

Do not force the I/O card onto the chassis connectors. Ensure that the I/O card is straight and parallel

to the chassis when you install the module onto the connectors. The pins on the connectors can be

damaged if the I/O card is not installed correctly.

Firmly press on the I/O card to ensure that the connectors mate with the chassis correctly.

Environmental Requirements, page 2-10

Power Requirements, page 2-13

Rack-Mounting Requirements, page 2-15

Temperature, Altitude, and Humidity, page 2-11

Ventilation, page 2-11

Space, page 2-12

Chapter 2

Preparing for Installation

OL-2190-02 B0