Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi - Halaman 26

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Perangkat Keras Jaringan Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Catatan Instalasi (14 halaman), Panduan Solusi (17 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Catatan Instalasi (24 halaman), Manual (19 halaman), Catatan Instalasi (36 halaman)

Installing the DFC3B and DFC3C Daughter Cards

Figure 17

Apply pressure here to seat power connector

Caution

Use care not to damage the connectors on the module. If you damage a connector, you will need to return

the module to Cisco for repair.

Position the installation bracket over the two male standoffs at the back of the DFC daughter card. Apply

Step 6

pressure only to the top of the bracket to fully seat the DFC3 daughter card on the module as shown in

Figure

When seating the DFC daughter card, do not apply pressure to any other location on the DFC daughter

Caution

card, especially the heat sinks. If you exert pressure on the heat sinks, they can break off of the

components they are attached to.

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

Seating the Power Connector

WS-X5530

18.

78-15893-08