Argo HIFAN HiFi Panduan Petunjuk Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemanas Argo HIFAN HiFi. Argo HIFAN HiFi 6 halaman. Ceramic fan heater
Halaman Cetak
OSCILLATION Button
When the unit is operating, touch
the
button to make the appliance
oscillate automatically, shifting the air flow
from left to right. The LED is switched on
simultaneously.
Touch the
button once again to interrupt
the oscillation and switch off the LED.
ON/OFF (STAND-BY) Button
Touching the
button will cause the low
power LED to light and the appliance will
begin to operate at low heating power
(1500W). Touching the
button once again
will lock all functions and place the unit in
stand-by. The power LED will switch off.To
switch off the fan heater completely, place the
on/off button in the "0" position.
The remote control has six membrane buttons whose functions are identical to those on the control
panel (already illustrated in detail).
Use Lithium/Manganese button cells, model no. CR2032 -3 V, compliant with Battery Directive no.
2006/66/CE (supplied with the remote control).
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES
(refer to the diagram below)
Open the battery cover at the rear of the remote control (press and pull the cover).
Place the battery into the cover, observing the correct polarity.
Insert the cover onto the remote control.
TIRA
PREMI
Inserimento pila
Information for correct disposal of the battery in accordance with the European Directive 2006/66/EC
Please replace battery when its electricity charge is used up: please do not eliminate this battery together with
normal household waste. It must be taken to special local community waste collection centres or to a dealer
providing this service. Disposing of a battery separately avoids possible negative effects on the environment and
human health deriving from an inappropriate disposal and enables its components to be recovered and recycled
to obtain significant savings in energy and resources. In order to underline the duty to dispose of this equipment
separately, the battery is marked with a crossed-out dustbin.
V 07/11
CONTROL PANEL
Buttons
Allow you to adjust the temperature
and timer settings of the appliance.
POWER LEVEL SELECTION Button
When the appliance is operating at the low heating power
setting, touch the
button to switch to the high power
setting and activate the LED at "2500W". Press the button
once again to switch back to the low power setting and
light the LED at "1500W".
REMOTE CONTROL
TIMER / TEMPERATURE Button
When the appliance is operating, the operating time
can be set by touching the
button: the timer display
shows a flashing 0 and the
operated to set the desired time, between 1 and 12
hours, with each touch corresponding with 1 hour.
The display shows the set time: wait 5" for the setting
to be confirmed. The unit will switch off automatically
at the end of the programmed time.
After the timer has been set, touching the
once again will allow you to set the temperature:
the display will show the default temperature of
25°C and, by operating the
desired temperature can be set between 15 and 35°C.
Once the desired temperature has been set, wait 5" for
the setting to be confirmed. After 5" the display will
show the ambient temperature once again. If no
settings are made, the default temperature is
25°C.When the ambient temperatureis≤-10°C, the LED
indicatorwill display"LO", when the ambient
temperatureis > 40°C,the LED indicatorwill display"HI".
When the ambient temperature isbetween-10°Cand
40°C,the LED indicatorwill displaythe ambient
temperature.
buttons can be
button
buttons, the
11