Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Perangkat Keras Jaringan Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Catatan Instalasi (14 halaman), Panduan Solusi (17 halaman), Catatan Instalasi (46 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Manual (19 halaman), Catatan Instalasi (36 halaman)

Installing the CSM

Software Requirements

The CSM cannot be used in a Catalyst 6500 series switch with the Catalyst operating system prior to the

Caution

7.5 release.

Table 4

CSM Software Requirements

CSM Software

Release

Software Part Number

3.2(1)

SC6K-3.2-CSM

Software Compatibility

Beginning with software release 2.1(1), backward compatibility is not allowed.

If the CSM software image version that you are using is more recent than the Cisco IOS software that is

specified for that release in

example, if you are running CSM software release 3.2(1) with Cisco IOS software release 12.1(11b)E,

the Cisco IOS software will not have the new CLI commands that support the CSM 3.2(1) features.

If the CSM software image version that you are using is older than the Cisco IOS software that is

specified for that release in

Cisco IOS commands. The CSM software will still run, but the new Cisco IOS commands will have no

effect.

Installing the CSM

These sections describe how to install the CSM:

•

Caution

The WS-X6066-SLB-APC Content Switching Module is not fabric enabled.

Catalyst 6500 Series Switch Content Switching Module Installation Note

lists the software versions for the CSM:

Hardware

Supervisor Engine 1A with

MSFC and PFC or

Supervisor Engine 2 Module

with MSFC 2

Table

Preparing to Install the CSM, page 9

Required Tools, page 9

Installing and Removing the Module, page 9

Catalyst Operating System

7.5

4, you will not have all the CSM features available to you. For

4, the older CSM application software will not understand the newer

Cisco IOS Release

12.1(13)E

78-15751-01