Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Perangkat Keras Jaringan Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 19 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Catatan Instalasi (14 halaman), Panduan Solusi (17 halaman), Catatan Instalasi (46 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Catatan Instalasi (24 halaman), Catatan Instalasi (36 halaman)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manual
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
7
GND
8
DTR
>
20
DCD
<

Catalyst 2926G Series Switch

The console and auxiliary (AUX) ports, located on the front panel of the Catalyst 2926G series switch,
are shown in the figure below.
Note: The AUX port is currently not supported.
Figure: Console and AUX Port Connectors
The console port, which is an EIA/TIA-232 asynchronous serial port with an RJ-45 connector, is a
full-featured DTE connection with hardware flow control.
Connect the terminal using a thin, flat RJ-45-to-RJ-45 rollover cable and an RJ-45-to-DB-9, an
RJ-45-to-D-subminiature female, or an RJ-45-to-D-subminiature male adapter (depending on the
terminal connector).
Table C-2: Catalyst 2926G Series Console Port Pinouts
Console Port
Pin (signal)
1 is looped to pin 8
2 (DTR)
3 (RxD)
4 (GND)
5 (GND)
6 (TxD)
7 (DSR)
8 is looped to pin 1
Note: An RJ-45-to-RJ-45 rollover cable and the adapters are provided in the console port accessories kit
shipped with your Catalyst 2926G series switch.
http://www.cisco.com/warp/public/473/9.html (7 of 19) [9/4/2003 12:36:03 PM]
Ground
Data Terminal Ready
Data Carrier Detect
Console Device
Connect to
n/a
DSR
TxD
GND
GND
RxD
DTR
n/a