Cisco 7200-I/O-GE+E Panduan Pengguna - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat Keras Jaringan Cisco 7200-I/O-GE+E. Cisco 7200-I/O-GE+E 16 halaman. Input/output controllers
Halaman Cetak
Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers
Examples
The following example displays sample output of the show interfaces gigabitethernet command:
Router# show interfaces gigabitethernet 0/0
GigabitEthernet0/0 is up, line protocol is up
Hardware is 82543 (Livengood), address is 00d0.ffb6.4c00 (bia 00d0.ffb6.4c00)
Internet address is 11.1.1.3/8
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex mode, link type is autonegotiation, media type is SX
output flow-control is on, input flow-control is on
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:04, output 00:00:03, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Related Commands
Command
show controllers
gigabitethernet
reliability 255/255, txload 1/255, rxload 1/255
2252 packets input, 135120 bytes, 0 no buffer
Received 2252 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
2631 packets output, 268395 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Description
This command displays initialization block information, transmit ring,
receive ring, and errors for the interface controllers about a Gigabit Ethernet
interface.
show interfaces gigabitethernet
12.1(5)T and 12.2(14) S
15