Cisco 7513 Series Panduan Memulai Cepat - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco 7513 Series. Cisco 7513 Series 44 halaman. Chassis replacement
Juga untuk Cisco 7513 Series: Manual Petunjuk Penggantian (26 halaman), Lembar data (11 halaman), Manual (30 halaman), Mempertahankan (20 halaman), Manual Petunjuk Penggantian (19 halaman), Manual Petunjuk Penggantian (22 halaman)

Start and Conﬁgure the System

Conﬁgure an Ethernet Interface

Step 1

To conﬁgure your system for an Ethernet

LAN, respond to the prompts as follows,

using your own IP address and subnet

mask information:

Configuring interface parameters:

Configuring interface Ethernet0/0:

Is this interface in use? [no]: yes

Configure IP on this interface? [no]: yes

IP address for this interface: 1.1.1.10

Number of bits in subnet field [0]:

Class A network is 1.0.0.0, 0 subnet bits;

mask is 255.0.0.0

Step 2

Enter yes to enable IPX on this interface,

using the IPX network number:

Configure IPX on this interface? [no]: yes

IPX network number [2]:

Step 3

Enter yes to enable AppleTalk on this

interface, to conﬁgure for extended

AppleTalk networks, and then enter the

cable range number. Enter the zone name

and any other additional zones that will

be associated with your local zone:

Configure AppleTalk on this interface? [no]:

yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]:

Step 4

At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

Conﬁgure a Synchronous Serial

Interface

Step 1

Enter yes to conﬁgure serial port 0:

Configuring interface Serial1/0:

Is this interface in use? [no]: yes