Cisco 7606 Panduan Pengguna - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat Keras Jaringan Cisco 7606. Cisco 7606 28 halaman. User guide
Juga untuk Cisco 7606: Brosur (8 halaman)

Halaman Cetak

1. Catalyst 6509 Switch and Cisco 7606 and Cisco 7609 Routers

Secure Operation of the Catalyst 6509 Switch and the Cisco 7606 and Cisco 7609 Routers

•

VPN Services Module (Cryptographic Accelerator) Self-Tests

•

Secure Operation of the Catalyst 6509 Switch and the

Cisco 7606 and Cisco 7609 Routers

The Catalyst 6509 switch and the Cisco 7606 router and the Cisco 7609 router with the VPN Services

Module meets all the Level 2 requirements for FIPS 140-2. Follow the setting guidelines provided in the

following sections to place the module in a FIPS-approved mode of operation. Operating this router or

switch without maintaining the following settings will remove the module from the FIPS-approved mode

of operation.

Initial Setup

Before configuring the router or switch, note these requirements:

•

Catalyst 6509 Switch, Cisco 7606 Router, and Cisco 7609 Router with VPN Services Module Certification Note

PRNG KAT

–

Power-up bypass test

–

Diffie-Hellman self-test

–

HMAC SHA-1 KAT

–

Conditional tests

Conditional bypass test

–

Pair-wise consistency test on RSA signature

–

Continuous random number generator tests

–

Power-up tests

Firmware integrity test

–

DES KAT

–

TDES KAT

–

SHA-1 KAT

Conditional tests

–

Continuous random number generator test

The crypto officer must ensure that the VPN Services Module cryptographic accelerator card is

installed in the chassis by visually confirming the presence of the VPN Services Module.

The crypto officer must apply tamper evidence labels as described in the

on page 18

of this document.

Only the crypto officer may add and remove network modules. When removing the tamper evidence

label, the crypto officer should remove the entire label from the chassis and clean the cover of any

grease, dirt, or oil with an alcohol-based cleaning pad. The crypto officer must reapply tamper

evidence labels on the router as described in the

The crypto officer must apply the opacity shield as described in the

page

18of this document.

"Physical Security" section

"Physical Security" section on page

"Physical Security" section on

18.

OL-6334-01