Cisco 7609 Menginstal - Halaman 14

Jelajahi secara online atau unduh pdf Menginstal untuk Perangkat Keras Jaringan Cisco 7609. Cisco 7609 22 halaman. Internet router
Juga untuk Cisco 7609: Brosur (8 halaman), Lembar data (5 halaman), Pertanyaan yang Sering Diajukan (5 halaman), Panduan Pengguna (28 halaman)

Halaman Cetak

Installing the Power Supplies in the Cisco 7609 Chassis

Connecting the System Ground

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Installing the Power Supplies in the Cisco 7609

Chassis

Cisco 7609 Internet Router Installation Guide

3-14

You must complete this procedure before connecting system power or turning on

the Cisco 7609 Internet Router.

To attach the grounding lug and cable to the grounding pad, perform these steps:

Use a wire-stripping tool to remove approximately 0.75 inch (19 mm) of the

covering from the end of the grounding wire.

Insert the stripped end of the grounding wire into the open end of the grounding

lug.

Use a crimping tool to secure the grounding wire in place in the grounding lug.

Locate and remove the adhesive label from the system grounding pad on the

Cisco 7609 chassis.

Place the grounding wire lug against the grounding pad, making sure there is good

metal-to-metal contact.

Secure the grounding lug to the chassis with two M4 screws. Ensure that the

grounding lug will not interfere with other Cisco 7609 hardware or rack

equipment.

Prepare the other end of the grounding wire and connect it to an appropriate

grounding point in your site to ensure adequate earth ground for the Cisco 7609

Internet Router.

The Cisco 7609 Internet Router power supply (AC or DC) is shipped separately

from the chassis. Remove the power supply from its shipping packaging. Install

and connect it to the site power by referring to the

Supply" section on page 5-5

on page

5-10.

Chapter 3

Installing the Cisco 7609 Internet Router

"Installing an AC-Input Power

or the

"Installing a DC-Input Power Supply" section

OL-5079-04