Cisco Aironet 1140 Series Panduan Memulai - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Memulai untuk Perangkat Keras Jaringan Cisco Aironet 1140 Series. Cisco Aironet 1140 Series 31 halaman. Autonomous access point
Juga untuk Cisco Aironet 1140 Series: Panduan Memulai (35 halaman), Panduan Konfigurasi (40 halaman), Lembar data (6 halaman), Panduan Memulai (37 halaman)
Halaman Cetak
22/09/2019
Cisco IOS
Red
errors
Cycling through blue, green,
red, and o
Con guring System Power Settings
After connecting the access point to a power source, its status LED might be amber, which can
indicate that the access point is unable to verify that the power source equipment (PSE) is
supplying su cient power. In such cases, you need to con gure settings on the access point or the
switch to identify your power source.
Identify your power source and switch condition, and then make sure that your devices are
con gured with an IP address.
Follow these steps to con gure the system power settings using the GUI:
Step 1 Open your browser and enter the access point IP address in the address eld. A login and
password screen appears.
Step 2 Enter the username Cisco and password Cisco. The username and password are case
sensitive.
Step 3 When the access point does not receive enough power for full operations, it is in low
power mode. If your access point is in low power mode, a warning message appears indicating
that all radios are disabled due to insu cient power. Click OK to continue. The System
Con guration page appears.
Step 4 Scroll down to the System Power Settings section as shown in Figure 4.
Figure 4 Low Power Mode Warning
Step 5 Set the power settings and power injector elds, and verify your switch status as shown in
Table 3.
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html
Getting Started Guide: Cisco Aironet 1140 Series Autonomous Access Point - Cisco
Boot environment failure
No Cisco image le
Boot failure
Software failure; try disconnecting and
reconnecting unit power
General warning; insu cient inline power
18/30