Sony NEX-5N Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Digital Sony NEX-5N. Sony NEX-5N 12 halaman. 10bar underwater housing
Juga untuk Sony NEX-5N: Spesifikasi (35 halaman), Spesifikasi (2 halaman), Garansi Terbatas (1 halaman), Brosur & Spesifikasi (13 halaman), Manual Fungsi (3 halaman), Buku Petunjuk (6 halaman)
Halaman Cetak
Inspection, Cleaning and Re-installation of the O-rings
Tools
Soft cotton buds that are free of chemicals or contaminants such as loose fibers.
•
•
Silicone grease supplied with the housing or other types of silicone grease specifically for use with
underwater camera equipment can also be used.
Procedure
The following procedure should be carried out on a clean, firm, level surface (e.g., on a table) to prevent
slipping especially when diving from a boat.
•
The O-ring can be extracted using the O-ring extractor tool that came with the housing, or push with
the flats of both thumbs or index fingers to gently stretch the O-ring on two adjacent sides thus
making a small loop protruding around the corner. The loop can then be grasped and the O-ring pulled over
the lip.
Clean the O-ring recess (the square groove where the O-ring sits) with a cotton bud.
•
Inspect the surface of the O-ring for contaminants and damages such as cuts or tears. This should be done
•
visually and by running the O-ring between thumb and index finger, sensing any texture abnormalities on
the surface.
If the O-ring is damaged or suspected of being damaged, discard it immediately.
•
Spare O-rings are supplied with your housing, or replacement O-rings can be ordered from 10Bar.
•
If the O-ring is contaminated, clean it with a clean cloth.
•
Re-inspect the O-ring after cleaning.
•
Once the O-ring has been inspected and verified good for use, apply and distribute evenly a SMALL
•
amount of silicone grease to the surface of the O-ring.
•
Replace the O-ring into the groove.
•
Run a finger over the O-ring to make sure it is seated properly.
9