Cisco Aironet 340 Series Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco Aironet 340 Series. Cisco Aironet 340 Series 13 halaman. Usb client adapter
Juga untuk Cisco Aironet 340 Series: Panduan Memulai Cepat (12 halaman), Catatan Rilis (14 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (12 halaman)

Connect and Power Up the Base Station

The base station provides data communications by using one of the following network

connections:

•

Built-in 56K modem using a dial-up connection

•

Cable or DSL modem (default setting)

•

PPP over Ethernet

•

Access Point

Caution

a data cable when the base station is powered up or damage to the base station could

result.

This guide describes how to set up a dial-up connection or a cable or DSL modem. If you are

using PPP-over-Ethernet mode to connect to an ISP or using the base station in Access Point

mode, refer to the Cisco Aironet 340 Series Base Station Hardware Installation Guide. You

must also refer to this guide if you have a radio card from another vendor.

Connecting to a Cable or DSL modem

Follow these steps to connect an Ethernet cable from the base station to a cable or DSL modem

(broadband Ethernet device):

Connect the Ethernet cable to the

RJ-45 Ethernet port on the back of the

base station.

Connect the other end of the cable to

the broadband device (cable or DSL

modem) on the wired LAN.

Connect the base station to a power

supply as described in the "Connecting

the Power Adapter" section.

Make sure the unit is disconnected from the power source. Do not connect

DSL

or cable modem

Ethernet cable

to DSL or cable

modem.

ET HE RN

TE LC O

5V DC