Cisco Aironet 340 Series Catatan Rilis - Halaman 6

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Perangkat Keras Jaringan Cisco Aironet 340 Series. Cisco Aironet 340 Series 14 halaman. Usb client adapter
Juga untuk Cisco Aironet 340 Series: Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (13 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (12 halaman)

Important Notes

Click Apply or OK to apply the setting. The access point or bridge reboots.

Step 3

Select WEP Key 1 as Transmit Key for EAP Authentication

If you use Network-EAP as the authentication type on your wireless network, you must select key 1 as

the transmit key on the access point or bridge AP Radio Data Encryption page. The access point or bridge

uses the WEP key you enter in key slot 1 to encrypt multicast and broadcast data signals that it sends to

EAP-enabled client devices. Because the access point or bridge transmits the WEP key used for multicast

messages to the EAP-enabled client device during the EAP authentication process, that key does not

have to appear in the EAP-enabled device's WEP key list. The access point or bridge uses a dynamic

WEP key to encrypt unicast messages to EAP-enabled clients. When you set up a non-root bridge or

repeater access point to authenticate as a LEAP client, the bridge or repeater derives a dynamic WEP

key and uses it to communicate with the root bridge or access point. Bridges and repeaters not set up for

LEAP authentication use static WEP keys when communicating with other bridges and access points.

If you do not use EAP authentication on your wireless network, you can select any WEP key as the

Note

transmit key. If you use EAP authentication and you enable broadcast key rotation, you can enable WEP

without entering WEP keys.

Important Notes

This section lists important information about access points and bridges running firmware version

12.01T1.

Reboot of Workgroup Bridges Required When Allowing More Than 20

With firmware version 12.01T1, you can select no for the Classify Workgroup Bridges as Network

Infrastructure setting on the AP/Root Radio Advanced page to allow up to 50 workgroup bridges to

associate to the access point or bridge. After selecting no for this setting, you must reboot workgroup

bridges associated to the access point or bridge.

Cisco Discovery Protocol Re-Enabled for Individual Interfaces on Reboot

The Cisco Discovery Protocol (CDP) feature is enabled by default, and CDP is enabled for each of the

access point's or bridge's individual interfaces by default. However, if you disable CDP for one of the

individual interfaces, the access point or bridge re-enables CDP for that interface when it reboots. If you

disable CDP completely, the access point or bridge does not re-enable CDP on reboot.

Release Notes for Cisco Aironet 340 and 350 Series Access Points and 350 Series Bridges Running Firmware Version 12.01T1

802.1x-2001 (formerly Draft 10)—This is the default setting in firmware versions 11.06 and

•

later. Select this option if client devices that associate with this access point or bridge use

Microsoft Windows XP EAP authentication or if LEAP-enabled client devices that associate

with this access point or bridge use radio firmware version 4.25 or later.

OL-3740-01