Sony SRG-120DS Panduan Petunjuk Pengoperasian - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kamera Digital Sony SRG-120DS. Sony SRG-120DS 24 halaman.
Halaman Cetak
Troubleshooting
Before bringing in your camera for servicing, check the following as a guide for troubleshooting the problem. If the
problem cannot be corrected, consult your Sony Service Center.
Symptom
The power of the camera is not turned
on.
Video is not displayed on the
connected video monitor.
Pan or tilt cannot be operated.
The EXPOSURE menu cannot be set
except for FULL AUTO.
The infrared remote commander does
not work.
The VISCA CONTROL is not available
with a computer connected to the
camera.
LAN communication is not available
with a computer connected to the
camera.
The camera does not work when
connected one-to-one to the IP remote
controller.
The camera cannot be operated at all.
Cause
The AC power adaptor is not connected
to the DC 12 V connector firmly.
The AC power cord is not inserted firmly
into the AC power adaptor or the AC
outlet.
-
The video connection cable is not
connected properly.
The exposure is not set correctly on the
camera.
The BOTTOM switch is not set correctly. Check that the BOTTOM switches 2, 5, 6, 7
The SYSTEM SELECT switch is not set
properly.
A menu is displayed on the computer
screen.
The panning or tilting range is limited.
WDR (VIEW-DR) is not set to OFF.
The CAMERA SELECT button you
pressed on the infrared remote
commander does not match the number
set with the IR SELECT switch on the
camera.
The computer is not correctly connected
to the camera.
The computer is not correctly connected
to the camera.
The computer is not correctly set.
A crossover cable is not used.
The SYSTEM SELECT switch on the
rear of the camera is not set correctly.
19
Remedy
Insert the power cord firmly as far as it will
go.
Insert the power cord firmly as far as it will
go.
Pull out the plug of the power cord from the
AC outlet, then reinsert it into the AC outlet
after waiting a while.
Make sure the connection between the
video monitor and camera is made
correctly.
Set the exposure correctly on the
EXPOSURE menu (page 9).
and 8 are set to OFF.
Check the output format of the video on the
camera and input format of video on the
video monitor.
Press the DATA SCREEN button on the
supplied infrared remote commander to
remove the menu from the computer
screen.
Change the PAN/TILT LIMIT setting on the
PAN TILT ZOOM menu (page 11).
After setting the WDR (VIEW-DR) to OFF,
select the MODE of the EXPOSURE
(page 9).
Press the CAMERA SELECT button
corresponding to the IR SELECT switch
setting on the camera (page 15).
Make sure the connection between the
computer and camera is made correctly.
Check that the BOTTOM switch on the
bottom of the camera is set correctly.
Check that the SYSTEM SELECT switch is
set to a position in which video signals are
output.
Make sure the connection between the
computer and camera is made correctly.
Check that the LAN (BOTTOM switch) is
set to ON.
Check the precautions in the setting of the
dedicated PC application.
Use a crossover cable for one-to-one LAN
connection.
Check that the SYSTEM SELECT switch is
set to a position in which video signals are
output.