DIGITEN WTC200 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Termostat DIGITEN WTC200. DIGITEN WTC200 9 halaman.
Juga untuk DIGITEN WTC200: Panduan Pengguna (8 halaman), Panduan Pengguna (12 halaman)

Halaman Cetak

Manual turn on/off function

Press and hold the M button for 3 seconds, the controller switches to the

manual mode, Always on or Always off will appear on the display. Short press

the M key to turn on/off the device. Long press the M key to exit the manual

control function.

Note: Short press

command

from

Troubleshoot

1, Current temperature is incorrect.

The remote update measuring value with 20 second a time. And if you use it

for the first time, please wait for about 5 minutes before the measurement is

stable.

2， Current temperature reach to the RUN value， but the controller don't work。

The remote send data to the receiver per 20 seconds, so please wait for more

than 20 seconds

3, Heating/cooling device is started too frequent

Please increase the difference between RUN and STOP

4, others

4.1, probe open circuit prompt: LCD current value shows Err

4.2, the measured temperature exceeds the measurement range, the current

value shows HH (high temperature), LL (low temperature)

WARRANTY

The DIGITEN products are guaranteed to the original owner for one year

against defects in workmanship and materials. Please contact us:

[email protected]

www.digit-en.com/support

WARNING

Do Not Overload

☆

This unit works with load up to 14A. If load is larger than 14A, it would become

very hot even burn the thermostat. That is very dangerous.

The probe is waterproof, but controller is not waterproof, so don't get water

☆

into the controller and outlet.

on the receiver to turn on/off loading until it receive

transmitter.