Sony CMT-CPX1 - Micro Hi Fi Component System Panduan Petunjuk Pengoperasian - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem stereo Sony CMT-CPX1 - Micro Hi Fi Component System. Sony CMT-CPX1 - Micro Hi Fi Component System 28 halaman. Sony micro hi-fi component system operating instructions

Halaman Cetak

The sound skips.

• Wipe the disc clean (page 22).

• Replace the disc.

• Try moving the system to a place without

vibration (e.g., on top of a stable stand).

• Try moving the speakers away from the system, or

placing them on separate stands. When you listen

to a track with bass sounds at high volume, the

speaker vibration may cause the sound to skip.

Play does not start from the first track.

• Press PLAY MODE repeatedly until both

"PROGRAM" and "SHUFFLE" disappear to

return to Normal Play.

Tuner

Severe hum or noise/stations cannot be

received.

• Set the proper band and frequency (page 8).

• Connect the antenna properly (page 4).

• Find a place and an orientation that provide good

reception, then set up the antenna again. If you

cannot obtain good reception, we recommend you

connect a commercially available external

antenna.

• The supplied FM lead antenna receives signals

along its entire length, so make sure you extend it

fully.

• Keep the antennas away from the system and

other components.

• Consult your nearest Sony dealer if the supplied

AM antenna has come off the plastic stand.

• Try turning off surrounding electrical equipment.

A stereo FM program cannot be received in

stereo.

• Press FM MODE on the unit until "STEREO"

appears in the display.

Tape deck

The tape does not record or play, or there is a

decrease in sound level.

• The heads are dirty. Clean them (page 23).

• The record/playback heads are magnetised.

Demagnetise them (page 23).

The tape does not erase completely.

• The record/playback heads are magnetised.

Demagnetise them (page 23).

There is excessive wow or flutter, or the sound

drops out.

• The capstans in the tape deck are dirty. Clean

them using a cleaning cassette.

Noise increases or the high frequencies are

erased.

• The record/playback heads are magnetised.

Demagnetise them (page 23).

The tape does not record.

• No cassette is loaded. Load a cassette.

• The tab has been removed from the cassette.

Cover the broken tab with adhesive tape

(page 23).

• The tape has wound to the end.

Optional components

There is no sound.

• Refer to General item "There is no sound."

(page 19) and check the condition of the system.

• Connect the component properly (page 17) while

checking:

– if the cords are connected properly.

– if the cord plugs are firmly inserted all the way.

• Turn on the connected component.

• Refer to the operating instructions supplied with

the connected component and start playing.

• Press FUNCTION repeatedly to select "MD" or

"VIDEO" (page 18).

The sound is distorted.

• Set the volume of the connected component

lower.

If the system still does not

operate properly after performing

the above measures, reset the

system as follows:

Disconnect the mains lead.

Reconnect the mains lead.

Press ?/1 to turn on the system.

Press TAPE x, CD x and ?/1 on the unit.

The system is reset to the factory settings. You

should set the settings you made, such as the

preset stations, clock, and timer.