Argo SKY PHOTO 230 Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Laminator Argo SKY PHOTO 230. Argo SKY PHOTO 230 8 halaman.

how to Use for cold lamination

1. Set temperature switch to „0"

2. turn on the power switch

3. insert the cold laminating film into the film entry

4. take out the laminated document/photo from the laminator's rear

5. When switch „HOt" to „COLD", be sure to cool down the machine's temperature before

cold laminating (it takes approx. 20-30 minutes).

notice

1. „HOt" operation can be started and continuous working when „READY" light on. the

machine has an auto-thermostat inside. During operation, „READY" green light might

flash, it high up the temperature automatically. „READY" will light on again when tem-

perature meets the set degree.

2. Before turn off the power, set temperature button to „0" position and operating approx.

10 minutes, such the service of heating rollers can be prolonged.

safety notice

• Read all instructions before use

• Do not leave cable where other may trip

• Do not attempt to open casing

• Do not use if wet

• Switch off and unplug when not in use

• Do not cover the heat vents when in use

• Do not touch the heat vents when the machine is working

• Do not put any items through the heat vents.

• Do not use if machine, cable, or socket is damaged

• Wait for cooling down the pouch, it may be hot

Nasza oferta w internecie: www.argo.pl