Sony MEX-N5100BT Panduan Petunjuk Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem stereo Sony MEX-N5100BT. Sony MEX-N5100BT 42 halaman. Bluetooth audio system
Juga untuk Sony MEX-N5100BT: Panduan Petunjuk Pengoperasian (38 halaman)
Halaman Cetak
To start playback
For details, see "Playing a BLUETOOTH Device"
(page 13).
To cancel pairing
Perform step 2 to cancel the pairing mode after this
unit and the BLUETOOTH device are paired.
To use a paired device, connection with this unit is
required. Some paired devices will connect
automatically.
1
Press CALL, rotate the control dial to
select [SET BT SIGNL], then press it.
Make sure that
0
lights up.
2
Activate the BLUETOOTH function on the
BLUETOOTH device.
3
Operate the BLUETOOTH device to
connect to this unit.
~~ or ~~ lights up.
Icons in the display:
~~
Lights up when handsfree calling is
available by enabling the HFP (Handsfree
Profile).
~~
Lights up when the audio device is
playable by enabling the A2DP
(Advanced Audio Distribution Profile).
T.ll
Indicates the signal strength status of
connected cellular phone.
To connect the last-connected device from
this unit
Activate the BLUETOOTH function on the
BLUETOOTH device.
Press SRC, then select {BT
P~ONE]
or [BT AUDIO].
Press ENTER to connect with the cellular phone, or
PAUSE to connect with the audio device.
Note
While streaming BLUETOOTH audio, you cannot
connect from this unit to the cellular phone. Connect
from the cellular phone to this unit instead.
Tip
With BLUETOOTH signal on: when the ignition is turned
to on, this unit reconnects automatically to the last-
connected cellular phone.
To install the microphone
For details, see "Installing the microphone (MEX-
N5100BT only)" (page 35).
When an iPhone/iPod with iOSS or later installed is
connected to the USB port, the unit is paired and
connected with the iPhone/iPod automatically.
To enable BLUETOOTH Auto Pairing, make sure
(AUTOPAIR] in (BT] is set to (ON] (page 22).
1
Activate the BLUETOOTH function on the
iPhone/iPod.
2
Connect an iPhone/iPod to the USB port.
Make sure that
0
lights up on the display of the
unit.
Notes
• BLUETOOTH Auto Pairing is not possible if the unit is
already connected to another BLUETOOTH device. In
this case, disconnect the other device, then connect
the iPhone/iPod again.
• If BLUETOOTH Auto Pairing is not established, see
"Preparing a BLUETOOTH Device" for details (page 8).