Cisco ASA 5508-X Pasang dan Hubungkan - Halaman 4

Jelajahi secara online atau unduh pdf Pasang dan Hubungkan untuk Perangkat Keras Jaringan Cisco ASA 5508-X. Cisco ASA 5508-X 6 halaman. Threat defense reimage guide
Juga untuk Cisco ASA 5508-X: Panduan Pemasangan Perangkat Keras (32 halaman), Panduan Memulai Cepat (8 halaman), Panduan Penyiapan yang Mudah (11 halaman), Panduan Memulai Cepat (9 halaman), Manual Perangkat Lunak (37 halaman), Manual (14 halaman)

Connect to a Console Terminal or PC

Your ASA ships with either ASA or Firepower Threat Defense software preinstalled. To reimage your device,

Note

see

Reimage the Cisco ASA or Firepower Threat Defense

Connect to a Console Terminal or PC

The serial ports provide administrative access to the ASA either with a console terminal or a PC. To configure

the ASA through the CLI, you must establish a connection between the ASA console port and either a terminal

or a PC.

This section describes how to connect to a console terminal or a PC, and contains the following topics:

You must install a USB device driver the first time a Microsoft Windows-based PC is connected to the USB

serial port on the ASA, otherwise the connection fails.

To uninstall the driver, use the Add Remove Programs utility or the Setup-exe program.

Note

Disconnect the ASA console terminal before uninstalling the driver.

Step 1

Obtain the appropriate driver (Cisco_usbconsole_driver_X_X_zip, where X is a revision number) for your ASA model

from the Cisco

Download Software

Step 2

Install the driver.

Step 3

Connect a USB 5-pin Mini USB Type B to the USB console port as shown in the following figure.

Mount and Connect

site, USB Console Software category.

Device.

Mount and Connect