Cisco ASA 5508-X Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Perangkat Keras Jaringan Cisco ASA 5508-X. Cisco ASA 5508-X 14 halaman. Threat defense reimage guide
Juga untuk Cisco ASA 5508-X: Panduan Pemasangan Perangkat Keras (32 halaman), Panduan Memulai Cepat (8 halaman), Panduan Penyiapan yang Mudah (11 halaman), Panduan Memulai Cepat (9 halaman), Manual Perangkat Lunak (37 halaman), Pasang dan Hubungkan (6 halaman)

Halaman Cetak

LEDs

The LEDs are located just off center on the front panel, and just to the left of the network ports on the rear

panel, with the SSD LED to the right of the Reset port. See

LED

Power

Status

Overview

USB port

A standard USB Type A port is provided,

allowing attachment of an external device such

as mass storage. See

Internal and External Flash

Storage, on page 6

for additional information.

SSD LED

Status light for installed solid-state drive (SSD).

See

LEDs, on page 4

and

Solid State Drive, on

page 7

for more information.

Description

Power supply status:

• Unlit—Power supply off.

• Green—Power supply on.

See

Power Supply Modules, on page 7

System operating status:

• Green—Normal system function.

• Amber—Critical alarm indicating one or more of the following:

Reset button

A small recessed button that if pressed for longer

than three seconds resets the ASA to its default

"as-shipped" state following the next reboot.

Configuration variables are reset to factory

default. However, the flash is not erased, and no

files are removed.

Note

SSD bay

Covered slot in which the SSD is installed. You

can replace this drive if it fails. See

Replace the SSD

Rear Panel, on page 3

• Major failure of a hardware or software component.

• Over-temperature condition.

• Power voltage outside the tolerance range.

You can use the service

sw-reset-button to disable the reset

button. The default is enabled.

for more information.

for the locations.

for additional power information.

Overview

Remove and