ACU-RITE 745604-NN Pembaruan Perangkat Lunak - Halaman 2

Jelajahi secara online atau unduh pdf Pembaruan Perangkat Lunak untuk Mixer Musik ACU-RITE 745604-NN. ACU-RITE 745604-NN 6 halaman.
Juga untuk ACU-RITE 745604-NN: Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (7 halaman), Pembaruan Perangkat Lunak (3 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (3 halaman), Pembaruan Perangkat Lunak (3 halaman)

Procedure for downloading the update files and placing them on a USB drive.

Download the update from

Controls Tab.



Unzip the downloaded archive insuring the target is the root level of your USB drive.



Insure the files setup.zip and setup.ini are transferred to a folder at the root level of your

USB drive named install, //MY USB DRIVE/install/

Procedure for updating the software



Shut down the control software using the normal method of pressing the Shutdown soft

key and then confirming the shutdown by pressing Yes.



Wait for the screen message which indicates that it is safe to switch off power, or restart.



Insert the USB memory device containing the folder named "install" on the USB memory

device.



Press ENTER to restart the system.



The software update will now be done automatically, taking approximately 10 - 20

minutes.

! A confirmation box will appear. If necessary, use the LEFT or RIGHT ARROW keys to select

Yes and then press ENTER.

When the update is complete, it will prompt you to remove the USB drive and restart. At this

time, remove the USB drive and press ENTER to restart. If the USB memory stick used for

installation is not removed, then the prompt to install the software will continue to appear on

subsequent power cycles.

! After installation and upon restart, you may receive a message prompt to confirm a firmware

update, accept the changes and RUN UPDATE.

(Note: This particular NC startup screen can take several minutes to display. Please be

patient. Do not shutdown control and reboot.)

After the system has restarted, it will start up normally to the control software.

Confirm that your count directions are correct.

upgrading software.)

If special machine functions were active, Press the SETUP hard key, then the "Install

Setup" soft key, enter passcode 8891, press ENTER

In the "Installation" dialogue, arrow down to the last option "Machine Functions" and

press ENTER

Configure the dialog to match your machine Note:(only required if special machine

function options are installed like demo, AMI, guards, etc.)

Press the USE hard key, then press the "Save Changes" soft key

http://www.acu-rite.com/software-updates.html

found under the

(These values should not change when