Sony MHC-RV222 Panduan Petunjuk Pengoperasian - Halaman 39
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem stereo Sony MHC-RV222. Sony MHC-RV222 48 halaman.
Halaman CetakMP3 audio tracks take longer to play back than
others.
• After the system reads all tracks on the discs,
playback may take more time than usual if:
– the number of albums or tracks on the disc is
very large.
– the album and track organization structure is
very complex.
The album name, track title and ID3 tag and
the CD-TEXT characters do not appear
correctly.
• Use a disc that conforms with ISO9660 level 1,
level 2 or Joliet in the expansion format.
• The disc ID3 tag is not ver. 1.
• The characters that can be displayed by this unit
are as follows:
– Upper cases (A to Z)
– Numbers (0 to 9)
– Symbols (< > * + , – / [ ] \ _)
Other characters may not be displayed correctly.
Tuner
Severe hum or noise/stations cannot be
received. ("TUNED" or "STEREO" flashes in
the display.)
• Set the proper band and frequency (page 18).
• Connect the antenna properly (page 8).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Try turning off surrounding electrical equipment.
• Set "CD POWER OFF" by CD power manage
function (page 19).
A stereo FM program cannot be received in
stereo.
• Press FM MODE repeatedly until "STEREO"
appears.
Tape deck
The tape does not record or play, or there is a
decrease in sound level.
• The heads are dirty. Clean them (page 42).
• The record/playback heads are magnetized.
Demagnetize them (page 42).
The tape does not erase completely.
• The record/playback heads are magnetized.
Demagnetize them (page 42).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty. Clean them
(page 42).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized.
Demagnetize them (page 42).
The tape does not record.
• No cassette is loaded. Load a cassette.
• The tab has been removed from the cassette.
Cover the broken tab with adhesive tape
(page 42).
• The tape has wound to the end.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Disconnect the power cord.
2
Reconnect the power cord.
3
Press x, PLAY MODE/TUNING MODE and
DISC 1 at the same time.
4
Press ?/1 to turn on the system.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.
GB
39