Sony MHC-VX777 Panduan Petunjuk Pengoperasian - Halaman 27

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem stereo Sony MHC-VX777. Sony MHC-VX777 36 halaman.

Halaman Cetak

Waking up to music

— Daily Timer

You can wake up to music at a preset time
every day. Make sure you have set the clock
(see "Setting the time" on page 8).
1
Prepare the music source you want to
play.
• CD: Load a CD. To start from a specific
track, make a program (see "Programming
the CD tracks" on page 13).
• Tape: Load a tape with the side you want
to play facing forward.
• Radio: Tune in the preset station you
want (see "Presetting radio stations" on
page 17).
2
Adjust the volume.
3
Press CLOCK/TIMER SET on the
remote.
"DAILY 1 SET" appears.
4
Press cursor V/v repeatedly to select
"DAILY 1 (2) SET", then press ENTER.
"ON" appears and the hour digits flash in
the display.
5
Set the time to start playback.
Press cursor V/v repeatedly to set the hour,
then press ENTER.
The minute indication starts flashing.
Press cursor V/v repeatedly on the remote
to set the minute, then press ENTER.
The hour indication flashes again.
6
Set the time to stop playback following
steps 4 and 5 above.
08OTH_MHC-VX777/VX555.p65 GB
7
Press cursor V/v repeatedly until the
music source you want appears.
The indications change as follows:
8
Press ENTER.
The type of timer (DAILY 1 or DAILY 2),
followed by the start time, stop time and the
music source appears, then the original
display appears.
9
Turn off the power.
To
Check the setting
Change the setting
Cancel the timer
operation
Tip
The power turns on 15 seconds before the preset time.
Notes
• When you use the Sleep Timer, Daily Timer will
not turn on the system until the Sleep Timer turns it
off.
• If the power is on at the preset time, the Daily
Timer does not work.
27
MHC-VX777/VX555/VX555J 4-232-651-12 (1)
t TUNER y CD PLAY T
t TAPE PLAY T
Do this
Press CLOCK/TIMER SELECT
on the remote and press cursor
V/v repeatedly to select the
respective mode (DAILY 1 or
DAILY 2), then press ENTER.
Start from step 1.
Press CLOCK/TIMER SELECT
on the remote and press cursor
V/v repeatedly to select
"TIMER OFF", then press
ENTER.
13/03/2001, 4:59 PM
27