Cisco ASA 5516-X Pasang dan Hubungkan - Halaman 2

Jelajahi secara online atau unduh pdf Pasang dan Hubungkan untuk Perangkat Keras Jaringan Cisco ASA 5516-X. Cisco ASA 5516-X 6 halaman. Threat defense reimage guide
Juga untuk Cisco ASA 5516-X: Panduan Pemasangan Perangkat Keras (32 halaman), Panduan Memulai Cepat (8 halaman), Panduan Penyiapan yang Mudah (11 halaman), Panduan Memulai Cepat (9 halaman), Manual Perangkat Lunak (37 halaman), Manual (14 halaman)

Connect Cables, Turn on Power, and Verify Connectivity

Figure 1: Chassis Installed in the Rack

What to do next

You can now install the cables and power cord, as described in

Connectivity, on page

Connect Cables, Turn on Power, and Verify Connectivity

After positioning or mounting the ASA, follow these steps to connect cables, turn on power, and verify

connectivity:

Step 1

Connect the network cables:

a) Management interface – Using this Management 1/1 Gigabit Ethernet port, you can connect a management computer

directly with an Ethernet cable, or you can connect the computer and the ASA to the same management network. Be

sure the PC is configured to obtain an IP address using DHCP.

You can configure any of the Gigabit Ethernet interfaces to be a management-only interface using the

management-only command. However, you cannot disable management-only mode on the Management 1/1 interface.

The following figure shows how to connect the network cables.

Mount and Connect

Connect Cables, Turn on Power, and Verify