Sony STR-DH130 Panduan Servis - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Servis untuk Sistem stereo Sony STR-DH130. Sony STR-DH130 36 halaman. Fm stereo / fm-am receiver
Juga untuk Sony STR-DH130: Panduan Petunjuk Pengoperasian (36 halaman), Panduan Pengaturan Cepat (2 halaman), Spesifikasi (2 halaman), Garansi Terbatas (1 halaman), Panduan Petunjuk Pengoperasian (35 halaman), Panduan Servis (36 halaman)

Halaman Cetak
Sony STR-DH130 Panduan Servis
[AM CHANNEL STEP 9 kHz/10 kHz SELECTION MODE]
(US, Canadian model only)
* Either the 9 kHz step or 10 kHz step can be selected for the AM
channel step.
* Procedure:
1. While pressing the [TUNING MODE] button, press the
[
] button to turn on the main power.
?/1
2. The message "9K STEP" or "10K STEP" appears for a
moment
and the channel step is changed.
[SOFTWARE VERSION DISPLAY MODE]
* The software version is displayed.
* Procedure:
1. While pressing the [SPEAKERS (OFF/A/B/A+B)] and the
[MUTING] buttons simultaneously, press the [
turn on the main power.
2. The destination and the software version are displayed.
Destination
D1
D2
UNKNOWN
U
U2
U
CA2
C
CEL
C
[KEY CHECK MODE]
* Button check
* Procedure:
1. While pressing the [SPEAKERS (OFF/A/B/A+B)] and the
[DIMMER] buttons simultaneously, press the [
turn on the main power.
2. The message "REST 13" appears.
3. Every press of any button other than the [
the buttons. The buttons which are already counted once are
not counted again. When all buttons are pressed "REST 00"
appears.
[VACUUM FLUORESCENT DISPLAY TEST MODE]
* All fl uorescent segments are tested. When this test is activated,
all segments light on at the same time, then each segment lights
on one after another.
* Procedure:
While pressing the [SPEAKER (OFF/A/B/A+B)] and the
[DISPLAY] buttons simultaneously, press the [
turn on the main power.
1. ALL segments light on.
SP A
OPT
HDMI
DTS
LFE
SW
COAX S-AIR
SP B
L
C
R
SL
S
SR
SBL SB SBR
2. Turn the [INPUT SELECTOR] control, confi rm display.
LFE
COAX S-AIR
SP B
L
R
S
SECTION 2

TEST MODE

] button to
?/1
D3
VERSION
N
K
2
1.
0
5
A
2
2.
0
5
E
L
3.
0
5
] button to
?/1
] counts down
?/1
] button to
?/1
-ES
96/24
CAT
MEMORY
RDS
ZONE 2
PL
ST
NEO:6
SAT
D.RANGE
MONO SLEEP
dB
k
Hz
m
ft.
MHz
-ES
MEMORY
ZONE 2
PL
ST
NEO:6
SAT
k
ft.
MHz
3. Turn the [INPUT SELECTOR] control, confi rm display.
SP A
SW
C
SL
SR
SBL SB SBR
4. Turn the [INPUT SELECTOR] control, all segments light off.
[HISTORY MODE]
* The state that the set is used is memorized.
* Procedure:
1. While pressing the [TREBLE +] and [SPEAKERS (OFF/A/
B/A+B)] buttons, press the [
and "HISTORY" is displayed.
2. Each time the [  ]/[  ] buttons on the remote commander is
pressed, the item is switched in order as follows.
Item
History
Count how many time of
A
protector happen
A
Total single power on time
A
Input function
HP ON/OFF
Volume
Bass
Treble
Balance
Total power on time
Muting
Power on counter
(Rebox Test Mode)
Protector Type
VACS step
Return to history
[PROTECTOR AUTO OFF]
* To disable auto off after protector occur
* Procedure:
1. While pressing the [TREBLE -] and [SPEAKERS (OFF/A/B/
A+B)] buttons, press the [
power.
II
x
2. "PROT OFF" appears and switch off the set.
D
EX
[SHIPMENT MODE]
* All preset contents are reset to the default setting.
* Procedure:
1. While pressing the [TUNING MODE] and the [MUTING]
buttons simultaneously, press the [
x
main power.
EX
2. "CLEARING" and "CLEARED" appear and switch off the
set.
STR-DH130
OPT
HDMI
DTS
96/24
CAT
RDS
D.RANGE
MONO SLEEP
] button to turn on the power
?/1
Display
HISTORY
COUNT xx
xxxxxHxx01
FUNCTION
HP xxx
VOL xxx
BASS xxx
TREB xxx
F xxx
xxxxxHxx02
MUTE xxx
REBXxxxx
PROTxxxx
VACS xx
HISTORY
] button to turn on the main
?/1
] button to turn on the
?/1
II
D
dB
Hz
m
7