ACU-RITE Mill PWR G2 Pembaruan Perangkat Lunak - Halaman 2

Jelajahi secara online atau unduh pdf Pembaruan Perangkat Lunak untuk Mixer Musik ACU-RITE Mill PWR G2. ACU-RITE Mill PWR G2 3 halaman.
Juga untuk ACU-RITE Mill PWR G2: Pembaruan Perangkat Lunak (7 halaman), Pembaruan Perangkat Lunak (3 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (3 halaman), Pembaruan Perangkat Lunak (6 halaman)

Procedure for downloading the update files and placing them on a USB drive.

Download the update from

Controls Tab.



Unzip the downloaded archive insuring the target is the root level of your USB drive.



Insure the files setup.zip and setup.ini are transferred to a folder at the root level of your

USB drive named install, //MY USB DRIVE/install/

Procedure for updating the software



Shut down the control software using the normal method of pressing the Shutdown soft

key and then confirming the shutdown by pressing Yes.



Wait for the screen message which indicates that it is safe to switch off power, or restart.



Insert the USB memory device containing the folder named "install" on the USB memory

device.



Press ENTER to restart the system.



The software update will now be done automatically, taking approximately 10 - 20

minutes.

! A confirmation box will appear. If necessary, use the LEFT or RIGHT ARROW keys to select

Yes and then press ENTER.

When the update is complete, it will prompt you to remove the USB drive and restart. At this

time, remove the USB drive and press ENTER to restart. If the USB memory stick used for

installation is not removed, then the prompt to install the software will continue to appear on

subsequent power cycles.

! After installation, should you get a message:

On startup, to confirm a firmware update, accept the changes and RUN UPDATE.

(Note: This particular NC startup screen can take several minutes to display. Please be

patient. Do not shutdown control and reboot.)

After the system has restarted, it will start up normally to the control software.

http://www.acu-rite.com/software-updates.html

found under the