Cisco ASR 5000 Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perangkat Keras Jaringan Cisco ASR 5000. Cisco ASR 5000 18 halaman. Applying power and verifying the installation
Juga untuk Cisco ASR 5000: Panduan Instalasi (33 halaman), Prosedur Instalasi (8 halaman), Panduan Instalasi (37 halaman)

Halaman Cetak

Chassis Installation

Table 1: Operating Temperature and Humidity Recommendations

Operating Temperature

Operating Humidity

Mounting Options

There are two options for mounting the chassis in a standard equipment rack or telecommunications cabinet:

• Flush Mount: In this configuration, the flanges of the mounting brackets are flush with the front of the

• Mid-mount: In this configuration, the flanges of the mounting brackets are recessed from the front of

Weight Considerations

The shipping weight of the chassis is approximately 160 pounds (72.57 kg). Please consider the following

recommendations before proceeding:

• If available, use an equipment lift to lift and move the chassis during the installation process.

• If no lift is available, reduce the weight according to the instructions in the

• At least two people are required to perform the installation. These individuals should be physically able

• When lifting any heavy object, it is important to remember to bend at the knees and lift with your legs.

Unpacking the ASR 5000 Chassis

Important

The chassis ships in a wooden container that is 28.25 in. (64.135cm) wide by 36.75 in. (93.35cm) high by

33.75 in. (85.75cm) deep. The container consists of an upper and lower section. The upper section forms the

sides and top of the container. The lower section serves as the bottom of the container. The upper and lower

chassis. This is the default configuration as shipped as is commonly used with 4-post racks and equipment

cabinets. Refer to

Flush Mount Installation of the Chassis, on page

the chassis. This configuration is required when mounting the chassis in a 2-post rack. To do this, install

the mounting brackets toward the middle of the chassis on either side. Refer to

of the Chassis, on page

10.

Chassis Prior to Installation, on page

approximately 125 lbs. (56.7 kg).

to lift and control the weight of the chassis.

Bending at the waist and lifting with your back could cause personal injury.

Before unpacking the chassis, use a pallet jack to move the container as close to the final installation site

as possible.

0 degrees C to +55 degrees C

32 degrees F to +131 degrees F

20 percent to 80 percent, non-condensing

6. These procedures reduces the weight of the chassis to

Mounting Options

Mid-Mount Installation

Reducing the Weight of the

ASR 5000 Installation Guide