ACU-RITE MILLPWR G2 Pembaruan Perangkat Lunak - Halaman 6
Jelajahi secara online atau unduh pdf Pembaruan Perangkat Lunak untuk Mixer Musik ACU-RITE MILLPWR G2. ACU-RITE MILLPWR G2 6 halaman.
Juga untuk ACU-RITE MILLPWR G2: Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (6 halaman)
Halaman Cetak
The helix step requires a tool diameter greater than 0. Check for tool diameter > 0 before running
a helix step and display an error message if necessary.
Corrected a problem with the Custom Pocket cycle sometimes missing an Island.
Fixed an issue where a contour was not properly repeated when the tool diameter is different.
Corrected some issues with the feature to automatically switch the DRO to INC mode at Z-Axis
manual operation prompts.
The Scale Factor field in Job Setup is now checked for a valid range of entry. If a value greater
than "100" or less than "0.1" is entered, the value will automatically revert back to the safety
default of "1". When a Scale Factor other than "1" is active in the system, the Scale status window
at the top of the screen will now highlight this with an alternate background color.
Fixed an issue where the Blend's feed rate was not changed by Change Steps step function.
Corrected an issue in which when setting the Datum, sometimes an error 220-0020 could be
displayed.
Corrected an issue in which the W-Axis coupling settings would be lost when upgrading to R6-
SP3.
Corrected a couple of graphics issues, in which Pan settings would be applied in reverse (horiz
vs. vert), and in which Reset Graphics was resetting too many parameters.
Corrected an issue where the Near Zero Warning Bar would not always be visible in INC mode of
the DRO as it should have been.
Corrected an issue with the Set RPM feature; if a spindle gear change was required, upon
pressing GO to complete the gear change, the system would incorrectly try to start running the
loaded program instead of just completing the RPM change, resulting in an unexpected 'Paused'
state.
If any issues are encountered, please contact your service representative for assistance or
contact technical support at
if you have any questions.